This warranty applies to Products that you or an authorized BlendMount dealer have installed, but only for defects in manufacturing - not conditions caused by the improper installation. This limited warranty does not cover defects or damage due to abuse, misuse or improper installation. This limited warranty covers only Products labor is not covered.
IRAD 950 VS 900 FREE
J28 Design, manufacturer of BlendMount brand mounts and accessories ("Products") that are purchased through the BlendMount Online Store or an authorized dealer will be free from factory defects, under normal use and service, for a period of one year starting from the date that is the earlier of retail sale and delivery, or installation. To obtain warranty service, return the affected component(s) with proof of purchase, at your expense, within the limited warranty period to J28 Design.
LIMITED WARRANTY FOR BLENDMOUNT® CUSTOMER
IRAD 950 VS 900 INSTALL
If you are unable to use a voltmeter we recommend taking your vehicle to an auto stereo install shop.
IRAD 950 VS 900 FULL
If you do not agree to these terms, do not use this product and return it for a full refund. Consult with your vehicle's dealer for any questions about your vehicle's electrical system. will not be held responsible for any damage to, interference with, or malfunction of your vehicle's electrical system resulting from installation or use of the MTPC. That should define which two ports in that harness into which you would plug the MirrorTap, the black Prong into #4 above, and the Red to #7.ĭisclaimer: J28 DESIGN INC. Touch each of the wires in that harness with the red probe, and note which one(s) gives you +12-14 volts, turn the ignition off to verify that the volt readings go down to zero or close to zero.Ĩ. Put the black probe on the ground wire found in #4.ħ. Put the voltmeter into VDC mode, to measure DC volts, turn the ignition to the on position.Ħ. Turn the ignition to the on position, then back to off, and make sure it beeps regardless of ignition position.ĥ. For each wire that beeps, that means that wire is grounded. Put the black probe on that ground, and touch the back of each exposed wire connector in the mirror harness with the red probe.Ĥ. Find a ground on the car somewhere, like a bolt under the dash, or a metal cross member.ģ. First set your voltmeter to the continuity setting (should beep when you touch the red and black probes together, telling you they are shorted).Ģ.
Guidelines on Using a Voltmeter to Locate Power and Groundġ. Voltmeter How do you check voltage with a Voltmeter?
IRAD 950 VS 900 PROFESSIONAL
This BlendMount Kit includes everything needed for a professional looking installation: Others: Visit your Dealer or local Car Audio Shop for installation. DIY'ers: Our installation instructions include the Step-by-Step VoltMeter process for determining the +12V Switch and Ground harness slots. Instead, a tight, protective sheathing with texture that looks factory, just like our MirrorTap Power Cords. This HardWire Kit for your Cobra, Uniden, K40, Radenso Whistler Radar Detector or BlackVue Dashcam is 8 feet in length and has an inline fuse so 12 Volt "ignition" power can be safely obtained from the nearest source.
0 kommentar(er)
